Adding Products To The Start Screen - Jura IMPRESSA Z9 One Touch TFT Instructions For Use Manual

4 Permanent settings in programming mode
Adding products to the
start screen
30
O T Press the P button to exit programming mode.
'Please select product:'
In the program item 'Product
find all the products stored as standard in your IMPRESSA. You can
move any of these products to your preferred position on the start
screen and make it one of your favourites.
You can also change the products shown in the product selector. To
do this, go to the program item
ming' and press the
delete a product or products. In the program item
settings (3/7)' / 'Classic-library', press the
button to add a product or products again.
Example: The '2 espressi'
corner of the start screen.
Precondition: 'Please select product:'
O T Press the P button.
'Maintenance status (1/7)'
g T Turn the Rotary Switch until the program item
settings (3/7)'
T Press the 'Classic-library'
'Classic-library'
E Next select the button of the product you want to move to the
start screen. No product is prepared at this point.
E Select the 'No product'
on the start screen empty.
T Press the '2 espressi'
T Press the
'Next'
T Press the 'Add to favourites'
'Select position'
T Press the button at the bottom right.
'Do you want to replace the current product?'
T Press the 'Yes'
'Saved' appears briefly on the display.
'2 espressi'
O T Press the P button to exit programming mode.
'Please select product:'
settings (3/7)' /
'Product settings (3/7)' /
'Remove from product selector'
'Add to product selector'
product appears in the bottom right-hand
is displayed.
is displayed.
button.
button if you want to leave a position
button.
button.
button.
button.
'Classic-library' you will
'Program-
button to
'Product
'Product