Beam SD7 series User Manual page 43

Activate Alert Mode
Alert mode can be activated by one of the following two methods:
1. Pressing the SOS button on the top of the Iridium Extreme handset.
2. If the alert loop is broken (OPEN) . This feature must be enabled in the
Eagle application.
Once triggered into the Alert mode, the Track LED flashes Red for 10 seconds.
The internal buzzer will beep 3 times (intervals: 3sec on 1sec off) at the loudest
volume.
Once triggered, a countdown will appear on the screen of the Iridium Extreme.
The user will have 20sec to press the right soft key labelled CANCEL to stop the
Emergency Mode if initiated accidently.
To trigger a second alarm, the alarm loop needs to be reconnected and then
broken again.
NOTE:
The Alert Loop (externally wired distress button) MUST be
configured in the Eagle before use. This is disabled by default.
IMPORTANT:
Please refer to the Iridium Extreme User Manual for configuration
of the Track and Alert message format, destinations, and intervals.
43