Beam SD7 series User Manual page 27

5. Connect the YELLOW wire to the vehicle accessory power. If the
accessory power is unavailable, this may be connected to a vehicle
ignition voltage. It is recommended to add a 1A (supplied) fuse between
them. The accessory wire enables the DriveDOCK Extreme to turn on
and off as the vehicle key is enabled or disabled. If this function is not
required, the YELLOW wire MUST be connected to the RED wire.
6. Once all the components have been installed, connect the 4-way
Microfit connector to the DriveDOCK Extreme and turn the DOCK on.
Wiring for a Marine Application
When installed in a marine application using the DC power cable, the
YELLOW wire can be wired to a suitable panel switch which will allow the
DriveDOCK Extreme to be turned off when not in use.
RED (+) Vin 9 to 32VDC
BLACK (-) OV Power Ground
YELLOW (IGN) Ignition / Accessory
To Battery Positive Terminal
(3A Fuse recommended)
To Negative Terminal or chassis
To ACC switched power
(1A Fuse recommended)
27