Hardware Device Problems; Hard Disk Drive Problems - Getac M230 User Manual

Resolution cannot be adjusted to desired setting.
 Make sure that the VGA driver is installed correctly.
The external monitor displays nothing.
Make sure that the monitor is turned on.

Make sure that the monitor's signal cable is properly connected.

Switch the display to the monitor by pressing the Fn+F9 hot key or

change the display through the settings in Display Properties.
Simultaneous display/multi-display does not work.
Make sure that you turn on the external monitor before turning on the

computer.
Press the Fn+F9 hot key to toggle through the display options or change

the settings in Display Properties in Windows.

Hardware Device Problems

The computer does not recognize a newly installed device.
The device may not be correctly configured in the BIOS Setup program.

Run the BIOS Setup program to identify the new type.
Make sure if any device driver needs to be installed. (Refer to the

documentation that came with the device.)
Make sure if the device needs any jumper or switch settings. (Refer to

the documentation that came with the device.)
Check the cables or power cords for correct connections.

For an external device that has its own power switch, make sure that the

power is turned on.

Hard Disk Drive Problems

The hard disk drive error message appears on the screen.
The hard disk drive has defects. Ask your dealer for help.
