Configuring The Wlan; Connecting To A Wireless Network - Getac M230 User Manual

Turning Off/On the WLAN Radio



Your computer has a built-in Fn+F11 WLAN hot key to switch the WLAN
on/off. The WLAN indicator (
ready for WLAN connection.
If you need to temporarily turn off the radio, press Fn+F11. To resume
network connection, press Fn+F11 again.
It takes approximately 30 seconds for your computer to make a successful
WLAN connection and approximately 10 seconds to disconnect.

Configuring the WLAN

After driver installation, you can use the WLAN utility to configure and
monitor your WLAN connection. If you are using Windows Vista, you can
also configure WLAN through Control Panel  Network and Internet
Connections  Network Connections  Wireless Network Connection.

Connecting to a Wireless Network

To connect to a wireless network:
1. Make sure that the WLAN radio is on (controlled by Fn+F11).
2. Click Start  All Programs  Intel PROSet Wireless  Intel PROSet
Wireless.
3. If any wireless network is detected, the following window appears on
screen.
) glows to indicate that the computer is