Optional Fiber Optic Cable Connection - Graco 244592 Instructions-Parts List Manual

Installation
Optional Fiber Optic Cable
Connection
An optional fiber optic fitting is shipped unassembled
with the gun. If an ES (kV) display module is used,
install the fitting in the FO port of the manifold. See F
3., page 10, for a schematic of the fiber optic connec-
tions.
1. Remove the plug (120) from the fiber optic port, and
install the fiber optic fitting (5, shipped loose with the
gun). See F . 6..
IG
5
120
Fig. 6. Fiber Optic Fitting
14
2. Remove the nut (AA) from the fiber optic fitting (5)
3. Push the cable (BB) into the fitting (5) until it bot-
.
IG
Fig. 7. Fiber Optic Cable
Most of the fiber optic light transmission loss occurs at
the bulkhead splices. For the strongest light signals, use
a minimum number of bulkhead splices. A maximum of
two splices, with a total of 108 ft (33 m) of cable, is rec-
ommended.
4. See manual 308265 to install a Graco ES Display
TI1737A
and slide the nut over the end of the fiber optic cable
(BB). See F . 7..
IG
toms out. Tighten the nut (AA) to secure the cable.
5
BB
AA
Module.
TI1581A
309298J