Table of Contents
Advertisement
Lens Installation
Before setting up the projector, install Projection Lens on the projector.
Before installation, check where the projector is used and prepare a suitable lens. For the specifications of
Projection Lens, contact sales dealer where you purchased the projector.
- Lens installation and replacement should be made by the qualified service personnel.
- When setting the projector after lens installation, be sure to replace a Lens Cap to protect a surface.
- When carrying or holding up the projector, be careful not to put your hands on lens part. It may
damage lens, cabinet, or mechanical parts.
Note:
Positioning Projector
This projector is designed to project on a flat projection
surface.
Note:
Picture Level and Pitch Adjustment
The projection angle is adjustable up to 5 degrees upward
and downward respectively by rotating front and back
feet.
To raise the projector, rotate the feet clockwise.
To lower the projector or to retract the adjustable feet,
rotate the feet counterclockwise.
To correct keystone distortion, press the KEYSTONE
button on the remote control or select Keystone from the
menu (see pages 14, 31, 41, 45).
+
DS
750 User Manual
020-000210-01 Rev.1 (06-2009)
Installation
SCREEN
REAR
ADJUSTABLE
ADJUSTABLE
FEET (Refer to
FEET
p.10)
17
Advertisement
Table of Contents
