Axis 5570e User Manual page 93

AXIS 5570e/AXIS 5670e User's ManualSection 5: Setting Up - IBM Mainframe (zSeries)
Device Statement Explanation
Specifies the JES default page definition.
The value
procedures.
The value
CARRIAGE
procedures.
The value
definition is to be used as default. The name specified here, or the JES3 system default, is
the PSF default page definition.
CHARS Specifies a default JES3 font.
Specifies the number of pages between data-set checkpoints. If checkpoint intervals are too frequent, printer
performance is significantly reduced. If intervals are too infrequent, and a PSF error occurs, the job has to be
CKPNTPG
reprocessed from the last checkpoint. In this case, printer performance is significantly reduced if PSF errors
continue to occur. The recommended starting value is 100.
Identifies the printer device type. For the AXIS 5570e/AXIS 5670e you should specify the parameter value
DTYPE
PRTAFP1
Specifies a unique FSS for this printer DEVICE statement. The value must match the value coded for the
FSSNAME
FSSNAME parameter in the corresponding FSSDEF statement.
HEADER
Specifies if job and data set header pages are printed. If DPF is installed, you may need to specify HEADER=YES.
Specifies the name of the printer FSA. Each printer FSA should have a unique JNAME. This unique JNAME is 8
JNAME
characters or fewer and must correspond to its label on the
statements for the PSF startup procedure specified in the
DEVICE Statement:
A DEVICE statement is required for each printer. The DEVICE
parameters create JES3 default values that are used unless other
values are specified in the JCL application program. The DEVICE
statement can contain the following parameters:
specifies that the page definition can be changed during startup
YES
specifies that the page definition cannot be changed during startup
NO
specifies that the un-prefixed name, 1 to 4 characters long, of the page
aaaa
. This parameter is required.
, , and
CNTL ENDCNTL PRINTDEV
parameter. This parameter is required.
PNAME
93