Axis 5570e User Manual page 221

AXIS 5570e/AXIS 5670e User's Manual
Notes:
• The examples in this section describe how you can configure the available logical printers
using a standard Web browser. If you want to set them directly by editing the config file,
just enter the values for the corresponding parameters.
• The examples should only be viewed as suggestions how to configure the logical printers.
You should, of course, configure them according to the needs of your network.
• In the Parameter List chapter of this manual, you can find a complete list of the AXIS
5570e/AXIS 5670e parameters.
Character Set
Conversion
Example:
Your network contains a host using the character set ISO 8859-2 and a host using the
character set DEC.
A common problem in a multiple host environment is that different
hosts use different ASCII character sets. As a result of this, language
specific characters (such as å ü ô ñ) are sometimes printed
incorrectly.
The AXIS 5570e/AXIS 5670e solution to this problem is to assign a
character set conversion filter to a logical printer, and then link that
logical printer to the host causing the problem.
You select your desired conversion filter by setting the Character Set
Conversion (PRx_CSET.) parameter. The output from the conversion
filter is always IBM PC Set 2 (Code Page 437), and this is the
character set the printer must be set up for.
In order to direct print jobs to the printer connected to the AXIS
5570e/AXIS 5670e, you should assign the host to a separate logical
printer, and install a character set conversion filter.
Follow the instructions below to change the conversion filter (USB1 is
used as an examlpe here):
1. From the print server's internal Web page, select Admin | Logical
Printers.
2. Select the PR1 tab.
Section 11: Configuration Possibilities
221