Blade Preparation And Installation - Casablanca Isotope C30G45H Owner's Manual

BlADE hARDwARE (not to scale)
Blades (5)
Blade installation
Step 3a. locate the Casablanca logo on the end
of the blade as shown in Figure #1. Slide the end of
the blade with the three holes into the slot located
on the blade ring. (Make sure that the Casablanca
logo is facing downward.) using three blade
screws and washers, attach the blade to the blade
ring, as shown in Figure #2. install three screws and
washer one by one using the provided screwdriver.
Tighten securely by hand only. Repeat until all five
blades have been installed on to the fan as shown
in Figure #3.
(Figure #1)
BladE INSTallaTION
CaSaBLanCa
LoGo
I
sotope
Blade Screws and
Washers (16)
BLade
WaSheR
(Figure #2)
(Figure #3)
®
Phillips
Screwdriver
BLade
SCReW
11