Casablanca Isotope C30G45H Owner's Manual page 9

Step 2f. using both hands, lift the fan body from the
hook and position the hanging slots on both sides
of the fan body, using the two fan mounting screws
located on the ceiling mounting plate. Slide the two
slots on both sides of the fan body between the head
of the screws and rotate the fan body clockwise into
the elongated slots as shown in Figure #7.
Step 2g. install the other two fan mounting screws
by holding the fan body cover to the ceiling mounting
plate as shown in Figure #8. Tighten all four screws
until hand tight.
Step 2h. Before going to the next step, locate the two
sets of canopy ring tabs that are on the top edge of
the canopy as shown in Figure #9. now locate the two
sets of canopy tab holders found at the top of the fan
body near the ceiling as shown in Figure #10.
hanGinG
SLot
(Figure #7)
Fan MountinG
SCReWS
(Figure #8)
(Figure #9)
CanoPY
taB hoLdeR
(Figure #10)
I
®
sotope
CanoPY RinG
taBS
CanoPY
RinG
9