Ducati MONSTER S2R 1000 Use And Maintenance Manual page 88

OBJECT IN MIRROR ARE
CLOSER THAN THEY APPEAR
Cod. 433 1 166 1A
1
VEHICLE EMISSION CONTROL LABEL
Engine displacement : 944
E
This vehicle conforms to U.S. EPA and California regulations
Applicable to 1998 model year new motorcycles.
Evap family :
HOT AIR INLET
3
MOTORCYCLE NOISE EMISSION CONTROL INFORMATION
THIS 1998 DUC46P0944
MEETS EPA NOISE EMISSION REQUIREMENTS OF
THE FEDERAL TEST PROCEDURE.
MODIFICATIONS WHICH CAUSE THIS MOTORCYCLE TO EXCEED FEDERAL
NOISE STANDARDS ARE PROHIBITED BY FEDERAL LAW.
SEE OWNER'S MANUAL.
7
88
Manufactured by
GVWR: 925.9 Lbs (420 kg)
GAWR front: 319.7 Lbs (145 kg) with
GAWR rear: 606.2 Lbs (275 kg) with
This vehicle conforms to all applicable Federal Motor Vehicle Safety standards in effect on the date of
manufacture shown above. Type classification: Motorcycle
Vehicle I.D. No.: ZD M 1TB9P X WB00 00 0 1
2
cc. Engine family :
Engine displacement:
Engine family:
Engine exhaust control system:
Evap family:
HOLDING
Via A.C.Ducati,3
40132 BOLOGNA
ITALY
ITEM
IGNITION TIMING:
IDLE SPEED (RPM):
IDLE MIXTURE:
TO HORIZONTAL MANIFOLD
VALVE CLEARANCE (in & ex):
TO VERTICAL MANIFOLD
SPARK PLUG: CHAMPION
SPARK PLUG GAP (mm): 0.5 0.6
4
MOTORCYCLE, ZDM1TB9PXWB000001
80 dBA AT 4675
DATE:
HOLDING
0/70ZR17 tire, MT 3.50x17 RIM at 32.7
170/60ZR17 tire, MT 5.50x17 RIM at 36.9
VEHICLE EMISSION CONTROL INFORMATION
9 44 cc THIS VEHICLE CONFORMS TO U.S. EPA AND
CALIFORNIA REGULATIONS APPLICABLE TO 1998
WDUCC0944ST2
MODEL YEAR NEW MOTORCYCLES AND IS
MFI
CERTIFIED TO 1.4 HC G/KM ENGINE FAMILY
EXHAUST EMISSION STANDARD IN CALIFORNIA
ENGINE TUNE-UP SPECIFICATIONS
SPECIFICATIONS INSTRUCTIONS
2¡ bTDC at idle speed No adjustment
1200 – 0.12 mm No adjustment
No adjustment
Opening 0.05 – 0.12 mm
See Service Manual
Closing 0.03 – 0.12 mm
RA4HC
OIL: SAE 20W50
FUEL: Unleaded gasoline
HOLDING - BOLOGNA - ITALY
CAUTION
RPM BY
NEVER FILL TANK SO FUEL LEVEL RISES INTO FILLER
NECK. IF TANK IS OVERFILLED, HEAT MAY CAUSE
FUEL TO EXPAND AND FLOW INTO EVAPORATIVE
EMISSION CONTROL SYSTEM RESULTING IN HARD
STARTING AND ENGINE HESITATION.
Cod. 432 1 233 1A
8
07/97
PSI cold.
PSI cold.
Cod. 432 1 234 1A
(Only Canada)
HELMET HOLDER
UNDER THE SEAT
5
Tensione catena (sul cavalletto laterale)
Chain Tension Adjustment (on side stand)
30 ÷ 32 mm
6
ATTENZIONE! Per evitare perdite di carburante dal tubo di sfiato,
evitate di sollevare il serbatoio quando questo pieno oltre la me-
t à .
ATTENTION! To avoid fuel leaks from the breather pipe, do not lift
the tank when it is more than half full .
9