P_ID
Read Projector ID.
Syntax: p_id
> p_id
Projector Serial Number=123456
SIZE
Native image size on the HD2+ engine is 1280 x 720. Parameters are entered in decimal.
Syntax: size {HSIZE} {VSIZE}
> size 1280 720
Size: 1280X720
STS
Display Shutter Status.
Syntax: STS
> STS
Shutter is On !
V+, V-
Enable (V+) or disable (V-) VERBOSE mode on the serial interface. When VERBOSE is enabled all messages –
informational, error and status, etc. – are sent as human readable text. When disabled those messages are sent as a 6
character ASCII group. There are two types of messages: critical and non-critical. Non-critical messages can be enabled
or disabled using the M+ and M- commands. The first character of non-critical messages is a percent sign (%). Critical
messages are headed by an exclamation point (!). The next two characters form a unique 8-bit hexadecimal code
identifying the message (see below). The last three characters are a dollar sign ($) followed by a <CR> and <LF>.
DGAMMA and most of the DEBUG/Maintenance commands output verbose messages regardless of whether VERBOSE
is enabled or disabled.
BOXLIGHT PRO80S3 Projector Preliminary User's Manual
Show Projector ID
Display Size
- 640 ≤ HSIZE ≤ 1280, 480 ≤ VSIZE ≤ 720
Display Shutter Status
VERBOSE Mode Control
P_ID
SIZE
STS
V+, V-
Page 23 of 33
Need help?
Do you have a question about the PRO80S3 and is the answer not in the manual?