BOXLIGHT PRO80S3 User Manual page 14

2.4 User Commands
Command Brief Description
CLOSE Close Shutter and put Formatters in Curtain Mode
DGAMMA DGAMMA Dowlnoad
FPOL TOGGLE the Film Projector Lockout Polarity
Gamma Select Gamma Table
GETP Get IR Remote
IR+ Enable IR Remote
IR- Disable IR Remote except POWER Button (default at Power-up)
LH Display Lamp 1 or 2 Age Data
LAMPON1 Turn On Lamp1*
LAMPON2 Turn On Lamp2*
LAMPOFF1 Turn Off Lamp1*
LAMPOFF2 Turn Off Lamp2*
M+ If V- enable display of non-critical (informational) messages – preceded by %
M- If V- disable display of non-critical (informational) messages – preceded by %
OFF Main Power Shutdown
ON Main Power ON
ONS
Main Power ON and Start Signal Lamp mode
OND Main Power ON and Start Dual Lamp mode*
OPEN Open Shutter and put Formatters in Normal Projection Mode
P ID Check Projector Serial Number
SIZE Set Display Size
SETP Set Lamp Power Mode*
STS Check Shutter Status
V+ Enable Verbose Mode
V- Disable Verbose Mode (see M+ and M- above also)
VER Display Controller Firmware Revision
2.5 Enhanced Color Correction Commands
Command Brief Description
ECC Enable/Disable P7 Color Correction and Select Target Data
MDNLD Download Measured Color Gamut Data for Storage in BLUE Formatter EEPROM
RDMCGD Display Measured Color Gamut Data
RDTCGD Display Specified Target Color Gamut Data
TDNLD Downlaod User-Defined Target Color Gamut Data for Storage in EEPROM
∗ 1
: mark for MH-69 only.
BOXLIGHT PRO80S3 Projector Preliminary User's Manual
User Serial Commands
DEBUG/Maintenance Serial Commands
∗
Page 14 of 33