Beam PotsDOCK Extreme Installation & User Manual page 35

RJ11 POTS Phone Use
Mobile Originating
1. Lift the RJ11/POTS phone handset "OFFHOOK" and listen for the dial tone.
2. Dial (using the full country codes) on the RJ11 telephone keypad.
3. A message will display on the Iridium Extreme handset to indicate the
call is progressing.
4. Once the call is connected, the STATUS LED will flash to indicate a call is
in progress.
5. Place the RJ11/POTS phone handset "ON HOOK" to terminate the call.
Mobile Terminating
1. The RJ11/POTS phone will sound its ringer.
2. Lift the RJ11/POTS phone handset "OFFHOOK" to answer the call.
NOTE:
When the privacy handset is used to originate or answer a call, the
RJ11/POTS interface will be disabled. Therefore if you un-hook the
connected POTS phone while the privacy handset is in use, you will
hear an unavailable tone. However, you can still transfer the audio
to a connected Bluetooth® headset by pressing the Bluetooth®
button.
NOTE:
The PotsDOCK internal ringer will also sound during an incoming call.
This can be changed by a single press of the Ringer button, whilst out
of call. (Please refer to the section "Ringer Selection" for more details
on pg.38)
35