Table of Contents
Advertisement
By default, the PotsDOCK Extreme will stay on for 20 minutes after this input is
switched off and if a call is in progress while this occurs, the PotsDOCK Extreme
will stay on for 20 minutes after the call is terminated.
Please follow the steps below to connect the DC power cable to the vehicle
battery power and the PotsDOCK Extreme.
1.
Place, but do not connect, the 4-way Microfit connector on the DC
power cable beside the 4-way power connector on the rear cable loom
of the PotsDOCK Extreme.
2.
Route the other end of the DC power cable to the connection point.
DO NOT apply power until the following steps are completed.
3.
Connect the black wire to the negative terminal of the battery or the
vehicle chassis (if negatively grounded chassis).
4.
Connect the RED wire to the positive terminal of the battery. It is
recommended to add a 3A fuse (supplied) between them.
5.
Connect the YELLOW wire to the vehicle accessory power. If the
accessory power is unavailable, this may be connected to a vehicle
ignition voltage. It is recommended to add a 1A (supplied) fuse between
them. The accessory wire enables the PotsDOCK Extreme to turn on
and off as the vehicle key is enabled or disabled. If this function is not
required, the YELLOW wire MUST be connected to the RED wire.
6.
Once all the components have been installed, connect the 4-way
Microfit connector to the PotsDOCK Extreme and the DOCK on.
Wiring for a Marine Application
When installed in a marine application using the DC power cable, the
YELLOW wire can be wired to a suitable panel switch which will allow the
PotsDOCK Extreme to be turned off when not in use.
26
RED
(+) Vin 9 to 32VDC
BLACK
(-) OV Power Ground
YELLOW (IGN) Ignition / Accessory
To Battery Positive Terminal
(3A Fuse recommended)
To Negative Terminal or chassis
To ACC switched power
(1A Fuse recommended)
Hide quick links:
Advertisement
Table of Contents
