Beam PotsDOCK Extreme Installation & User Manual page 28

Step 8 - Tracking & Alert Configuration (optional)
Tracking & Alert requires the installation of a GPS antenna, and setup of the
tracking and/or alerting messages.
Please refer to the Eagle software to enable and configure Tracking & Alert.
Please refer to the Iridium Extreme Handset User Manual to configure the
tracking and emergency alert operation and destinations.
NOTE:
If the BEAM alarm loop is to be used, remember to enable the
external loop in the Eagle settings. Once enabled, the loop will be
armed and activated with an open-loop condition.
To avoid false triggering, be sure to have the normally closed
button wired into the alert loop, before applying power.
Initiate a Quick GPS tracking message
When the TRACK button of the PotsDOCK is pressed, the Extreme Handset
will attempt to send a Quick GPS message (according to the settings of the
Extreme Handset)
Refer to Track Button/LED operation for further information.
Emergency alerting mode
If the Alert loop is configured in Eagle, the PotsDOCK will trigger the
emergency (SOS) function of the Extreme Handset. This triggering is
activated by a user breaking the alarm loop connected to the dock. The
Alert can also be activated by pressing the SOS button on the Extreme
Handset itself.
28