Beam PotsDOCK Extreme Installation & User Manual page 25

Step 6 - Connect the DC power cable to the PotsDOCK Extreme
Once all the components are installed, apply power to the PotsDOCK via
the 4-way Microfit connector using the AC/DC power adaptor or the DC
power cable.
A: Power from the AC/DC Adaptor
If the PotsDOCK is used inside a building where mains power is available,
it can be powered from the AC/DC power adaptor. The supplied AC/DC
power adaptor supports international AC voltage ranges for global
compatibility. Please follow the steps below to connect the power.
1. Ensure that the power adaptor cable has enough length to reach the
PotsDOCK cradle and it is plugged into a power outlet of suitable
safe power capability. If using a power-board extension, please
ensure that it is not overloaded.
2. Connect the 4-way output connector from the power adaptor to
the matching 4-way connector from the rear cable loom of the
PotsDOCK cradle as shown below.
Please note that while the PotsDOCK is powered by the AC/DC adaptor,
it will always be turned ON unless power is removed.
B: Power from the DC Power Cable
Power is supplied to the PotsDOCK Extreme via the 4-way Microfit®
connector using the DC power cable.
The DC power cable has three wires, RED, BLACK and YELLOW.
The RED and BLACK wires are used for the power connection. The
YELLOW wire can be connected to a vehicle's accessories, ignition or other
similar circuits to control the ON/OFF status of the PotsDOCK Extreme in
synchronization with a vehicles operation.
25