Beam PotsDOCK Extreme Installation & User Manual page 27

Step 7 - Bluetooth® Configuration (Optional)
PotsDOCK has an in-built Bluetooth® module for voice connectivity.
NOTE:
In this manual, when there is a reference to the Bluetooth® button or
the Bluetooth® LED it is referring to the button shown below located
on the front of the PotsDOCK Extreme.
To configure/pair to a Bluetooth® headset (audio) device:
1. Power up the PotsDOCK Extreme cradle.
2. Press and hold the Bluetooth® button on the cradle for 5 seconds,
until the cradle sounds a double (2) beep. The Bluetooth® LED will
then flash blue and orange.
3. Hold the headset (device) button(s) to enter the pairing mode
(please refer to the headset user manual).
4. Once the devices are successfully paired, the Bluetooth® LED on the
cradle will change to solid blue.
5. Bluetooth® can be turned ON with a single press, and OFF by
pressing and holding the Bluetooth® button for 2 seconds on the
cradle. The cradle will sound a single (1) beep when turning off. Once
paired, the PotsDOCK Extreme will automatically connect to this
device every time the PotsDOCK Extreme powers up.
You may repeat this process to pair more than one headset. Ensure only
one device is switched on during subsequent pairing configuration.
To clear (delete) all the registered devices from the cradle settings, press
and hold the Bluetooth button (10 seconds) until 3 beeps are heard.
NOTE:
Once a Bluetooth device is discovered, the PotsDOCK will attempt to
pair to that device by trying each of the password "0000", "1234", and
then the optional password set in the Eagle.
27