Changing The Volume Presetting Of The Signal Tone (Beep Volume); Changing The Presetting Of The Power-On Volume (On Volume); Restoring The Volume At Switch-On (Last Volume) - Blaupunkt MEMPHIS MP66 Operating And Installation Manual

Changing basic settings in the settings menu
The volume presetting for
phone calls appears.
➔
Adjust the desired volume us-
ing the volume control
the rocker switch
ments 1 to 50).
During the phone call, you can
always change the volume by
means of the volume control
Changing the volume presetting
of the signal tone ( Beep Volume)
If a signal tone sounds, you al-
ways hear it at the preset volume.
➔
Press the softkey
"Beep Volume").
The volume presetting for the
signal tone appears.
➔
Adjust the desired volume
using the volume control
or the rocker switch
ments 0 to 6).
You hear a signal tone at the se-
lected volume.
➔
If you do not want to hear any
signal tones, set the volume to
zero.
"BEEP OFF" appears on the dis-
play.
Changing the presetting of the
power-on volume ( On Volume)
You can confi gure the device so
that the playback after switch-
on always starts with the volume
set here. For this purpose, the
116
5
or
3
(incre-
5
.
9
(next to
5
3
(incre-
"On Volume" menu item must be
highlighted.
➔
Press the softkey
"On Volume").
The presetting for the power-
on volume appears.
➔
Adjust the desired volume
using the volume control
or the rocker switch
ments 1 to 50).
If you open the "Volume Set-
tings" menu again, the "On Vol-
ume" menu item is highlighted.
Restoring the volume at switch-
on ( Last Volume)
You can confi gure the device so
that the playback after switch-on
always starts with the previously
selected volume. For this pur-
pose, the "Last Volume" menu
item must be highlighted.
➔
Press the softkey
"Last Volume").
"Last Volume active" briefl y
appears on the display. If you
open the "Volume Settings"
menu again, the "Last Volume"
menu item is highlighted.
<
(next to
5
3
(incre-
;
(next to