Switching The Internal Amplifi Er; On/Off (Internal Amp); Resetting The Device To Factory; Settings (Norm Set) - Blaupunkt MEMPHIS MP66 Operating And Installation Manual

Switching the internal amplifi er
on/off ( Internal Amp)
If you connected the device to an
external power amplifi er via the
preamplifi er outputs (Preamp),
you can switch off the internal
amplifi er of the device as follows:
CAUTION!
No sound with switched-
off internal amplifi er!
If you switch off the internal am-
plifi er, you do not hear a sound
from the loudspeakers connected
to the device!
➔
Switch off the internal amplifi -
er only if you connected an ex-
ternal power amplifi er to the
preamplifi er outputs (Preamp)
of the device and you connect-
ed your loudspeakers to this
power amplifi er:
➔
Press the softkey
"Internal Amp").
The status of the internal am-
plifi er is displayed:
•
: The internal amplifi er
is switched on. Loudspeak-
ers connected to the device
play back the selected audio
source.
Changing basic settings in the settings menu
8
(next to
•
: The internal amplifi er is
switched off. Loudspeakers
connected to the device al-
ways remain mute. The loud-
speakers must be connected
to the external amplifi er.

Resetting the device to factory

settings ( Norm Set)
➔
Press the softkey
"Norm Set").
The "Norm Set" menu appears.
➔
Press and hold the softkey
for approx. two seconds.
"NORMSET ON" briefl y appears
on the display. The device is re-
set to the factory settings. Im-
ages and animations, which
you transferred to the device,
are deleted.
Note:
To exit the "Norm Set" menu
without resetting the device to
the factory settings, press the
A
OK button
@
ton .
Changing the scan time
( Scan Time)
➔
Press the softkey
"Scan Time").
The current scan time is dis-
played.
<
(next to
<
or the ESC but-
;
(next to
121