Displaying The Serial Number (Serial Number); Error Table - Blaupunkt MEMPHIS MP66 Operating And Installation Manual

Error table

➔
On the rocker switch
repeatedly press
increase the scan time.
➔
On the rocker switch
repeatedly press
decrease the scan time.
You can adjust scan times in in-
crements of 5 seconds form 5 to
30 seconds.
Error table
If the device does not function properly, switch the device off and on
again.
If problems still persist, you can easily correct the following problems.
Problem
The menus do not appear
as shown in these instruc-
tions.
The tuner cannot be adjust-
ed to the frequencies listed
in the technical data.
The display shows informa-
tion about the device.
The device is always silent,
even though it is correctly
connected.
If problems still persist, please contact an authorised workshop or the
Blaupunkt customer service (see the last page).
122
3
, Displaying the serial number
or to ( Serial Number)
Every device has a separate serial
3
, number. To display this number:
or to
➔
Possible cause
The device is not set to
your region.
The demo mode is acti-
vated.
The internal amplifi er is
switched off.
Press the softkey
"Serial Number").
The serial number is displayed.
Possible remedy
Set the device to your
region as described on
page 88.
Press and hold the MENU
?
button
Switch on the internal
amplifi er as described on
page 121.
:
(next to
for four seconds.