Test Procedures - EFD Ultra 1400 User Manual

Initial Test
Procedures
Testing in Timed Mode
•
•
•
•
•
•
Testing in Teach Mode
•
•
•
•
•
•
•
If you have any questions at this point, please call us now.
In the USA, call 800-556-3484 between 8:30 a.m. and 5:30 p.m. Eastern time.
In Europe, call +44 (0) 1582 666334.
In Asia, call +86 (21) 5854 2345.
In all other areas, call your authorized EFD distributor or +1-401-434-1680.
18
Follow steps in "Testing in Steady Mode" to purge your dispense tip with fluid.
Change to Timed mode by pressing the Teach button
Set time to 0.25 seconds.
Rest the dispense tip on the Dot Standards sheet.
Press the foot pedal to activate the dispense cycle. Note: the pedal only needs to be pressed for a
moment. The complete time will run once you activate the dispense cycle.
Changing the time changes the deposit size. If your dot is too small, increase the dispense time
to increase the deposit size. If your dot is too large, decrease the dispense time to decrease your
deposit size.
Follow steps in "Testing in Steady Mode" to purge your dispense tip with fluid.
Change to Teach mode by pressing the Teach button
Rest the dispense tip on the Dot Standards sheet.
Press the foot pedal to establish your dot size. Tapping the foot pedal repeatedly will have a
cumulative effect on the dot size and dispense time.
Continue to press the foot pedal until you achieve the correct deposit size.
Save the dispense time setting you just created by pressing the Teach button again. This
automatically exits Teach mode and returns you to Timed mode.
If needed, press the Teach button twice to reset to 0 and start over.
twice to reset the display to 000 seconds.
once so that the digital display flashes.