Multiple Ap Setup - Planet WNAP-6306 User Manual

Transmission Rate
ShortGi
Protection
Preamble Type
WLAN Partition
RF Output Power
WMM

5.4.2 Multiple AP Setup

The wireless AP supports multiple AP, if you need to open more than one AP, you can choose to open
vice AP function. The default status of secondary AP is disabled; you can select enable to enable the
secondary AP. Please refer to "Wireless Setup Basic" and "Wireless Security" for details.
5.4.2.1 Basic
The default status of secondary AP is disable, you can select enable to enable the secondary
AP. Please refer to 5.3.1.1 Wireless Basic
Transmit rate indicates the transmission speed of wireless LAN
access .The default setting is "Auto" and you can set this value
between 1-150Mbps range.
You can select "Enable" or "Disable" for shortgi. It is used to set
the time that the receiver waits for RF reflections to settle out
before sampling data.
Using 802.11b and 802.11g mixed mode may result in poor
network performance. By enabling 802.11 protection, it will
ameliorate performance of 802.11g devices in your wireless
network.
"Short Preamble" is suitable for heavy traffic wireless network.
"Long Preamble" provides much communication reliability; the
default setting is "Long Preamble".
This feature is to isolate the communication of wireless clients
connected with different AP. When this feature is enabled, each of
your wireless clients will be in its own virtual network and will not
be able to communicate with each other.
Set the wireless output power level. The default value is 100%.
To enhance wireless multimedia transfer performance (0n-line
video and voice).
for details
- 48 -
User's Manual of WNAP-6306