Technical Data; Specifications - Xerox Color J75 Press User Manual

2. Reinsert the container into the SquareFold Trimmer Module.
3. Ensure that the container is fully pushed in, and that the indicator light is not lit.
4. If fault persists, repeat the previous steps.
5. If fault persists, power off/on the machine.
6. If fault persists, call for service.
013-941
Cause: The Trimmer Waste Container is full or has a fault
Remedy: Perform the following:
1. Pull open the container and empty any trimmer scraps from it.
2. Reinsert the container into the SquareFold Trimmer Module.
3. Ensure that the container is fully pushed in, and that the indicator light is not lit.
4. If fault persists, repeat the previous steps.
5. If fault persists, power off/on the machine.
6. If fault persists, call for service.
013-943
Cause: Booklet Tray on the SquareFold Trimmer Module is full
Remedy: Perform the following:
1. Remove any booklets from the tray.
2. If fault persists, power off/on the machine.
3. If fault persists, call for service.

Technical data

Specifications

Item Specifications
Paper size
Note
The SquareFold Trimmer Module requires both Interface Module and the
Booklet Maker Finisher.
Trim capacity
Cut amount: 2-20 mm, adjustable in 0.1 mm increments
Xerox Color J75 Press
®
User Guide
Maximum: 13 x 18 in./330 x 457 mm
Minimum: 8.5 x 11 in./A4 SEF
5-20 sheet booklet (up to 80 imaged sides) at 24 lb./90 gsm
5-25 sheet booklet (up to 100 imaged sides) at 200 lb./80 gsm
SquareFold Trimmer Module
16-27