Maintenance; Replacing The Ohcf Feed Rolls - Xerox Color J75 Press User Manual

Oversized High Capacity Feeder (OHCF), 1 or 2 trays (Trays 6/7)
8. Return the rear skew adjustment lever to its left, default position.
9. Slide the right-side skew adjustment lever toward the front of the paper tray.
10. Gently push in the tray until it comes to a stop.
11. From the Tray Properties window, enter the correct paper information, including size,
type, weight, and if necessary, paper curl and/or alignment option.
12. Select OK to save the information and close the Tray Properties window.
13. Run your print job.
The paper is fed accurately without skew and the printed output is satisfactory;
your task is complete.
The paper is skewed and the printed output is unsatisfactory; proceed to the next
step.
14. Pull out the tray slowly until it stops.
15. Return the right-side skew adjustment lever toward the rear of the paper tray; this is
its default position.
16. Gently push in the tray until it comes to a stop.
17. If you are still having skew adjustment problems, refer to the Advanced Stock Setup
information located in the System Administration Guide.

Maintenance

Replacing the OHCF feed rolls

The OHCF feed rolls should be replaced when experiencing frequent multifeeds, single
feeds, or blank prints in the stack of the output prints.
Use this procedure to replace the OHCF feed rolls, which includes the following rolls:
Feed Roll
Nudger Roll
Retard Roll
12-8 Xerox Color J75 Press
®
User Guide