Assembly & Use; Stay Mounting Blocks; Checking Rack Fitment - Burley Moose Rack Owner's Instruction And Safety Manual

Stay Mounting Blocks

the mounting block can be installed with the bolt on
the inside or to the outside of the rack. Face them in the
direction that provides the best alignment for the stays
to mount to the bicycle. the stays can also be switched
left or right to get the best alignment for your bicycle.
1. Stay
2. rack stay block
3. rack stay receiver
4. M6 x 10 screw
5. M6 x 12 screw
6. M6 washer
5
3
1
MOOSE RACK

Checking Rack Fitment

It is very important that the rack is securely
attached to the lead bicycle.
check to see what type of mounting points are
on your bicycle. Most bicycles have threaded
mounting points near the rear axle of the
bicycle, one on each side, A, and one on each
side below the seat on the rear stays, B.
Some bicycles don't have mounting points at A.
this is probably a sign that the bicycle was not
designed for carrying heavy loads and a Moose
rack should not be attached to that bicycle.
29er Bicycles:
Mountain bikes with 29" wheels will fit the Moose
rack if the distance from the lower mounting
hole to the top of the tire is less than 13.75".
Some bicycles with very low mounting
6
points at B will not fit any rear cycle rack.
2
disc brakes may cause fit problems. Every
bicycle is different and there is a possibility
that a rack will not fit on certain bicycles.
4
ENG DEU FRA ESP
B
A
threaded mounting
points for rack
ASSEMBLY & uSE
7