Threading For Twin Needle - Husqvarna Designer Diamond User Manual

Threading for twin needle

Replace the sewing needle with a twin needle. Make
sure the presser foot is raised and the needle is in the up
position.
1. Raise the horizontal spool pin to the vertical position.
Raise the auxiliary spool pin to the vertical position.
Slide a large spool cap and a felt pad on each one.
Place the thread spools on the spool caps.
2. Bring the thread over and behind the Pre-Tension
Thread guide (A) and under the thread guide (B).
Follow the thread slot and place the thread between
the thread tension discs (C). Make sure that one thread
is on each side of the tension discs.
3. Thread down through the right-hand threading slot
and then upwards through the left-hand threading slot.
4. Bring the threads from the right into the take-up lever
(D) and down in the left-hand threading slot. Make
sure that one thread is inside the needle thread guide
(E) and the other one outside. Also make sure that the
threads do not become twisted together.
Thread sensor
If the upper thread breaks or bobbin thread runs out,
the machine stops and a pop-up message appears on the
screen.
If upper thread breaks: Re-thread the machine and touch
OK on the pop-up message. If bob bin thread runs out,
replace it with a full bobbin and continue sewing.
2:6
Set Up
C
D
E
A
B
E