Needle Threader; Threading For Twin Needle - Husqvarna Quilt Designer II User Manual

Needle Threader

The needle must be in the up position to use the
needle threader. We also recommend lowering the
presser foot.
1. Pull the needle threader all the way down, behind
the needle.
2. Bring it forward until the metal fl anges cover the
needle. A small hook will pass through the needle
eye.
3. Place the thread around the guide (a) and under
the fl anges in front of the needle, so the thread
catches into the small hook.
4. Let the needle threader gently swing back. The
hook pulls the thread through the needle eye and
forms a loop behind the needle. Pull the thread
loop out behind the needle.
5. Place the thread under the presser foot and cut
the thread.
Note: You cannot use the Needle Threader for the wing
needle, twin needle, triple needle or when the Buttonhole
Sensor Foot is on. When threading the nee dle manually
make sure that the needle is thread ed from front to back.
The white presser foot ankle makes it easy to see the eye
of the nee dle.

Threading for Twin Needle

1. Insert a twin needle. See page 16 "Changing the
needle".
2. Use a second thread spool or wind a bob bin with
the thread you are go ing to use as the second
up per thread.
3. Left needle (blue): Thread the machine as
explained on page 9 (Vertical Spool Pin) and
check to ensure that the thread lies between the
inner thread ten sion discs, and inside the last
thread gui de. Thread the left needle.
4. Right needle (red): Pull up the auxiliary spool pin.
Pla ce the large spool holder and a felt pad on the
spool pin.
5. Place the thread spool or the bobbin with the
second thread on the spool pin.
6. Thread the machine as before but this thread
should lie between the outer thread ten sion discs,
and outside the last thread guide. Thread the right
needle.
10
Learn your Quilt Designer II
1.
3.
a
4.
2.
5.