Stitch Program Commands; Sewing A Stitch Program - Husqvarna Designer Diamond User Manual

Stitch program commands

You can insert FIX, STOP and thread cut commands into
the stitch program. These commands will be included in
the stitch program and will always be performed when
sewing it.
Note: If creating a stitch program in Embroidery Mode, tie-offs will
be added automatically at the beginning and end, allowing you to
create a stitch program in between. The commands can be removed.
Insert a STOP by touching the STOP button on your
machine, if you want the machine to stop at a certain place
in your programmed stitch. This is useful for example at
the end of the stitch program if you want to sew it only
once or to create a stitch program in several rows.
Insert the thread cut if you want the machine to tie-off
and cut the threads and raise the presser foot.
Move the cursor to the position where you want to
add a command. Touch the button and an icon will be
added into the programmed stitch. This con rms that
the command is inserted and it also shows where the
command will be performed in the stitch program.
Note: The commands will appear on the screen in the order you
program them.

Sewing a stitch program

To sew the stitch program, return to Sewing Mode or
Embroidery Edit. Close Program mode by touching the
OK icon.
Adjustments made in Sewing Mode or Embroidery Mode
will affect the entire programmed stitch. However, these
changes will not be saved if you return to Program mode.
If you make changes while in Embroidery Edit, and you
save them, these changes will be saved as a design and can
only be edited again in Embroidery Edit.
However, you can always open a stitch program made in
Sewing Mode, in Embroidery Mode.
5:6 5:6
Program