Threading For Twin Needle; Thread Cutter; Thread Sensor - Husqvarna Viking Sapphire 960Q User Manual

THREADING FOR TWIN NEEDLE

Replace the sewing needle with a twin needle. Make
sure the presser foot is raised and the needle is in the up
position.
1. Lift the spool pin up and all the way to the right.
Lock the spool pin in the vertical position by slightly
spools smaller than the medium size spool cap, place a
felt pad under the thread spool.
spool should rotate in a clockwise direction when the
thread reels off the spool.
3. Thread the machine as described on page
LEFT NEEDLE:
2:5. Check to ensure that the thread lies between the
left
manually.
4. Pull out the auxiliary spool pin and slide on the large
spool cap, place a felt pad under the thread spool.
5. Place the second thread on the spool pin. The second
spool should rotate in a counterclockwise direction
when the thread reels off the spool.
6. Thread the machine as before but this
RIGHT NEEDLE:
thread should lie between the right thread tension discs
the right needle manually.
Note: Activate and choose the correct needle width in Sewing Settings
in SET Menu to prevent damage to the needle or the presser foot.
Note: The weight and irregular surface of specialty threads such as
metallic increases the amount of friction on the thread. By reducing
the tension, the risk of needle breakage is prevented.

THREAD CUTTER

the thread before and after winding a bobbin. The second
thread after placing it in the machine. The third one is on
and bobbin threads. Pull both threads into the cutter from

THREAD SENSOR

When the bobbin thread is running low, the machine stops
and a pop-up appears on the screen. Replace with a wound
bobbin and continue sewing.
Note: When the bobbin thread is almost empty, the bobbin thread low
pop-up appears on the screen. You can continue sewing without closing
the pop-up before the bobbin thread runs out completly.
2:6
A
B
A
C
B