Table of Contents
Advertisement
Embroidery Stitch-Out
Change thread color
When it is time to change the needle thread, the machine
stops and the upper thread is cut. Change the spool of
thread and re-thread the machine. The next recommended
color number is shown in the pop-up message.
Cut thread end
After changing the thread, the machine will sew a few
stitches and then stop so you can cut the thread end.
Note: When Automatic Jump Stitch Trim is selected in the SET
menu, the thread end will be cut automatically. Simply remove the
thread tail that has been cut.
Embroidery is nished - Clear screen?
When the embroidery is nished, the machine will ask
you if you want to clear the screen. If you touch OK, the
designs will be deleted and you will go back to Embroidery
Edit. Touch Cancel to get back to your design and stay in
Embroidery Stitch-Out.
Design Positioning
Raise needle
When the needle is lowered with the handwheel to check
the needle position on the fabric, a pop-up message is
displayed when trying to adjust the hoop position. Check
the box to be able to ne tune the hoop position with the
needle lowered.
Note: Make sure the needle is above the fabric to prevent damage to
the needle and fabric.
Note: The warning cannot be disabled when the needle is below the
stitch plate.
8:12
Advertisement
Table of Contents
