Table of Contents
Advertisement
Sewing Settings
Twin Needle
Touch the Twin Needle icon to open a list for twin needle
width selections. When a twin needle size is selected, the
width of all stitches is limited for the selected twin needle
size to prevent needle breakage. The setting is kept until
you deselect the twin needle width.
When a twin needle size is selected, a pop-up message is
shown when turning on your machine. Another warning
pop-up message is shown when selecting a stitch that is
too wide for the selected twin needle size. The stitch width
of those stitches is automatically adjusted to t the twin
needle. Deselect Twin Needle to go back to normal sewing.
Stitch Width Safety
Select the Stitch Width Safety function when using a
straight stitch needle plate or a straight stitch presser foot.
The needle position is locked to center for all stitches to
prevent damage to the needle, presser foot or needle plate.
When turning on the machine with this setting activated
and for every stitch selection that is not a straight stitch, a
pop-up message informs you that it is set to straight stitch.
Deselect Stitch Width Safety to go back to normal sewing.
Note: Twin Needle and Stitch Width Safety cannot be used at the
same time.
Selective Thread Cutter Auto
To activate the function select the Selective Thread
Cutter Auto in the Sewing Settings. The threads are cut
automatically and the presser foot raises at color changes,
when an embroidery is nished or when you have
completed a buttonhole. When deselected, no Selective
Thread Cutter Auto will be performed.
Automatic Jump Stitch Trim
This machine features Automatic Jump Stitch Trim. This
function saves you time trimming after the embroidery is
completed. The default setting is on. As you embroider, the
machine will trim the top jump stitch thread and pull the
thread end to the underside of the fabric.
: The machine will also cut the thread after you have changed to
NOTE
a new color. Hold the thread end when you start embroidering again,
so that you can easily remove the thread end when cut.
Not all designs are programmed for Automatic Jump Stitch
Trim. Jump stitch trim commands can be added to any
design using the 4D™ Software.
Some embroidery designs you purchase may have
trim commands in them. To check if a design
includes trim commands you can open the design
in 4D™ Stitch Editor and look for the trim
command symbol.
Ultimate Interactive Screen
Note: If the front and back of your embroidery will be visible, turn
off the Automatic Jump Stitch Trim and cut the threads manually.
3:7
Advertisement
Table of Contents
