Open The Case; Inserting The Flash - Olympus PFL-01 Instruction Manual

Open the Case.

Insert the buckle opener of the accessory into the buckle opening
lever as shown in the figure (in direction
slowly (in direction
buckle opening lever with your thumb and index finger from the side
and pull it up slowly.

Inserting the flash

Carefully insert the FL-20 Electronic Flash into the hot shoe of this
case. Make sure that the protruding part of the camera's zoom
lever fits properly in the notch in case's zoom lever.
Follow the steps shown in the illustration; insert the flash all the
way into the hot shoe; turn and tighten the shoe lock dial of the
flash.
To remove the FL-20 from this case, follow these steps; turn and
loosen the shoe lock dial of the flash; holding the flash's dial firmly
with a finger, slide the case out of the flash's hot shoe.
CAUTION : • Be sure to turn the flash off before inserting it into this case.
•Do not apply excessive force to the flash when
inserting it.
• When removing the flash from this case, hold the
flash so as not to drop it.
). When not using the buckle opener, hold the
E-17
) Pull the buckle opener