Table of Contents
Advertisement
3. Installing the digital camera
Open the Case
1 Slide the lock knob towards the arrow direction (1 of figure below).
2 Slide and hold the slide lock towards the arrow direction (2 of figure below) and turn the open/close
dial clockwise (3 of figure below).
3 Turn the open/close dial to the position where it cannot be turned further.
4 Open the rear lid of the Case gently.
CAUTION:
• Do not exert too much force while turning the open/close dial. Doing so may damage the dial.
Attach the flash to the camera
1 Attach the flash supplied with the camera.
Make sure to set the light emitting part facing to front.
EN
2 Raise the ON/OFF lever to turn the power ON.
Note:
When using the flash supplied with the camera, light distribution unevenness may occur.
If the distribution unevenness occurs, use an external flash.
EN 13
Slide lock
Open
3
Open/close dial
Lock knob
ON/OFF lever
2
1
Advertisement
Table of Contents
