Installing The Digital Camera; Open The Case; Attach The Flash To The Camera - Olympus PT-EP14 Instruction Manual

3. Installing the digital camera

Open the Case

1 Slide the lock knob towards the arrow direction (1 of figure below).
2 Slide and hold the slide lock towards the arrow direction (2 of figure below) and turn the open/close
dial clockwise (3 of figure below).
3 Turn the open/close dial to the position where it cannot be turned further.
4 Open the rear lid of the Case gently.
• Do not exert too much force while turning the open/close dial. Doing so may damage the dial.

Attach the flash to the camera

1 Attach the flash supplied with the camera.
Make sure to set the light emitting part facing to front.
2 Raise the ON/OFF lever to turn the power ON.
When using the flash supplied with the camera, light distribution unevenness may occur.
If the distribution unevenness occurs, use an external flash.
Slide lock
2
Open
3
Open/close dial
Lock knob
ON/OFF lever
1
EN
EN 39