Open The Case; Mounting The Electronic Flash; Inserting The Silica Gel Bag - Olympus PFL-E01 Instruction Manual

Electronic flash waterproof case for the fl-36

Hide thumbs Also See for PFL-E01:

Table of Contents

Open the Case.

Insert a finger below each buckle lock/unlock

lever as shown in the illustration. Pinch the

buckle hook and pull it up slowly.

Mount the FL-36 flash on the Case's hot shoe as shown in the illustrations.

Slide the electronic flash all the way into the hot shoe.

Turn the shoe lock dial of the electronic flash to clamp it.

To remove the FL-36 flash from the Case:

Turn the shoe lock dial of the electronic flash to unclamp it.

Hold the dial of the electronic flash firmly with a finger, and slide it out from the hot shoe.

CAUTION

：• Be sure to switch the electronic flash OFF before loading.

• Do not apply excessive force when loading the electronic flash.

• When removing the electronic flash, hold it firmly so you don't drop it.

Before sealing the Case, insert the

accessory silica gel bag (for prevention of

fogging) between the right side of the

electronic flash and the Case. Insert the bag

so that the longer glued side is on the

inside.

CAUTION

：• Insert the silica gel bag as far as it will go at the specified location and with

• If the bag is only inserted part of the way, it will get caught by the O-ring

• Once silica gel has been used, its moisture absorption performance will be

the specified orientation. If the orientation is incorrect, the silica gel bag will

catch when the Case is sealed and water will leak into the Case.

when you try to seal the Case and water will leak into the Case

impaired. Always change the silica gel when you open or close the Case.

E-15

Table of Contents