Table of Contents
Advertisement
2.4 Choose the "Quietest" Channel for your Wireless Network
In locations where homes or offices are close together, such as apartment buildings or office complexes, there may be wireless networks
nearby that can conflict with your wireless network.
Use the Site Survey capabilities found in the Wireless Utility of your wireless adapter to locate any other wireless networks that are
available (see your wireless adapter's user manual), and switch your Router and computers to a channel as far away from other networks
as possible.
Experiment with more than one of the available channels, in order to find the clearest connection and avoid interference from neighboring
cordless phones or other wireless devices.
2.5 Connecting and Configuring your MyWay
The MyWay has been designed to be placed on a desktop. All of the cables exit from the rear for better organization. The display is
visible on the front of the MyWay to provide you with information about network activity and device status. See below for explanation of
each of the indication lights.
Front Panel
Wireless
I
nternet/LAN
LAN
3G
Line 1
Line 2
Power
Please note that all lights will flash simultaneously if a firmware upgrade takes place.
Rear Ports
SIM Slot
3G Antenna
LAN/WAN
LAN
Line 1
Line 2
Reset/WPS
Power
NetComm MyWay – 3G WiFi Router with Voice User Guide
8
Icon
Description
Solid blue light when WLAN is enabled. Blinks on traffic (data transfer)
LAN mode: Solid blue light when the router is connected via the LAN Ethernet Port
WAN mode: Lights up when the router is connected to the internet via fixed line WAN using PPPoE
and PPTP
Solid blue light when specific LAN connection is established. Blinks on LAN port traffic
Solid blue light when the MyWay is connected via 3G, blinks on traffic
Solid blue light when the handset connected to Line 1 is off hook, Blinks on incoming call
Solid blue light when the handset connected to Line 2 is off hook, Blinks on incoming call
Solid amber light when device is powered on. Blinking during device start up.
Insert your SIM card here (until you hear a click). Please be careful to insert the SIM in the correct orientation by
viewing the printed icon.
Attach in the 3G Antenna here in a clockwise direction.
Switchable LAN/ WAN Ethernet port for Fixed Line (ADSL/Cable/Satellite) connection or wired Ethernet clients
(Computers, Laptops, etc)
LAN Port for wired Ethernet clients (Computers, Laptops, etc)
Phone Port for Handset(s)
Phone Port for Handsets(s)
Hold this button down for over 10 seconds to reset to factory defaults.
Hold and release this button for less than 10 seconds to enable the WPS push-button-connect function.
Power connector, connects to a DC 12V 1.5A Power Adapter
YMLO-3G8WV
www.netcomm.com.au
Advertisement
Table of Contents
