Table of Contents
Advertisement
3 Using the MyWay to make and
receive telephone calls
The MyWay provides circuit switched voice services via two telephony line interfaces offering the ability to make and receive telephone
calls via a regular analogue telephone using the 3G mobile network.
Note: Please refer to your mobile service provider for activation of your voice service and information about the call charges that apply.
It's important to note that the MyWay has two separate line interfaces that share a single outbound/inbound telephone line. This means
that handset(s) connected via one port will not be able to use the line at the same time as handsets connected via the other port.
If a call is already in progress via the first port, the user on the handset(s) connected to the second port will receive a busy signal.
Incoming calls will ring and can be answered on either port, however once a call is answered from one port, handset(s) on the second
port will receive a busy signal.
3.1 Handset requirements
The MyWay allows you to make telephone calls over the 3G network using a standard analogue telephone via the built in RJ-11 Phone
ports. Please refer to the documentation provided by the manufacturer of your analogue telephone for assistance with the operation of
your telephone handset.
3.2 Maximum REN Loading
Please note that each of the line interfaces on the MyWay is capable of supporting multiple analogue telephones connected via splitters.
The ringer equivalence number (REN) for each line is 5. Therefore, a maximum of 5 handsets each with a REN number of 1 can be
connected to each line port.
Before you start make any phone call, make sure you checked the following:
1. You have an activated 3G SIM card inserted prior to powering on the MyWay.
2. Your MyWay is powered on and in running condition.
3. A working analogue telephone connected into either the Line 1 or Line 2 port.
4. You hear the dial tone and the Line LED on the front of your MyWay should light up after lifting the handset.
3.3 How to place a call
To make a call, simply lift the handset and dial the number following the instructions provided by your telephone handset manufacturer.
3.4 How to receive a call
When an incoming call is received, both Line 1 and Line 2 lights will start flashing and any phones connected to the MyWay will ring.
Answer the telephone following the instructions provided by your telephone handset manufacturer to conduct the call.
Please note that if the call is answered from a telephone connected to Line 1, telephones connected to Line 2 will receive an engaged
tone for the duration of the call.
If no phone is connected the MyWay, all incoming calls will be transferred to Voicemail (if enabled on the device).
3.5 Accessing voicemail
To access your voicemail, please refer to voice user manual provide from your service provider
NetComm MyWay – 3G WiFi Router with Voice User Guide
14
YMLO-3G8WV
www.netcomm.com.au
Advertisement
Table of Contents
