Table of Contents
Advertisement
5.2.6
Advanced Routing
This page allows you to configure static and dynamic routing rules for your MyWay.
5.2.6.1 Advanced Routing – Static
Static Routing allows computers that are connected to your MyWay to communicate with computers on another LAN segment which
are connected to it via another router. To set a rule, you need to specify the following:
•
Destination
•
Subnet mask
•
Gateway
•
Interface
5.2.6.2 Advanced Routing – Dynamic
Dynamic Routing uses the RIP protocol to allow the MyWay to adapt to changes in the network. RIP enables the device to determine the
best route for each packet based on the "hop count" or number of hops between Source and Destination. To enable Dynamic Routing,
select Enable from the drop box and click Apply.
5.2.7
DHCP Client List
This page allows you to view the current DHCP clients that have obtained IP leases from your MyWay. The MAC address, assigned IP
address and the expiry period is shown for all computers who have automatically obtained addresses from the MyWay. Please note
that this list is stored in the device's volatile memory, and is therefore cleared if the device is reset or if any changed are applied to
configuration.
YMLO-3G3WV
www.netcomm.com.au
NETCOMM MYWAY - 3G WiFi Router with Voice
NetComm MyWay – 3G WiFi Router with Voice User Guide
27
Advertisement
Table of Contents
