Playing Auxiliary Sources - Bang & Olufsen BEOSOUND 9000 Manual

42
> Nice to know
Press to select extra equipment
A. AUX
∧
Press to raise the volume
VOL
∨
Press to lower the volume
VOL
Press to silence the speakers
MUTE
immediately – Press again to recall
the sound
Nice to know:
• Extra equipment must be connected to the AUX-
socket on the back of the BeoSound 9000. For
further information, please refer to the Setting-
up guide which is also enclosed with the
BeoSound 9000.
• If you are recording from the BeoSound 9000
onto Audio tape, you will not be able to listen
to another source, CD or radio, other than the
one you are recording. If you change source
while recording, you will then record this new
source onto your Audio tape.
• You will be able to record digital signals from
the BeoSound 9000 to a Digital Audio Recorder
via the digital output socket. Please refer to the
Setting-up guide for further information.

Playing auxiliary sources

The A. AUX button selects extra Bang &
Olufsen equipment, you connect to the
BeoSound 9000.
You will then hear the sound from the
extra source through the speakers of
your BeoSound 9000 but all control
operations must be carried out on the
extra equipment you connect.
While the source is playing, you can,
though, use the functions which relate
to sound as shown to the left on the
page and the special sound adjustment
functions, please refer to the chapter
on sound adjustment on pages 40-41.
You can record the source, CD or radio,
you are playing on the BeoSound 9000
via the AUX-socket onto Audio tape.
The recording function must be carried
out via the Audio tape recorder's own
controls.
Headphones...
when you are using BeoSound 9000 as
a stand-alone audio system or when it
is used in a fully integrated system, you
will be able to connect Bang & Olufsen
or non-Bang & Olufsen headphones to
the BeoSound 9000 to the headphones
socket.
The socket for headphones is situated in a low
position on the side of the BeoSound 9000 cabinet
BEO4
Press to select AUDIO TAPE
A TAPE
Press LIST to display PHONO or
LIST
A.AUX according to the equipment
you connect
then
Press GO to select the sources
GO
Note: Please contact your Bang & Olufsen dealer
for complete information about which Bang &
Olufsen or non-Bang & Olufsen products can be
used with the BeoSound 9000.