Adjusting Sound - Bang & Olufsen BEOSOUND 9000 Manual

40
Press to access the treble adjustment
TREBLE
function
Press to access the bass adjustment
BASS
function
Press to access the balance
BALANCE
adjustment
L
Press to raise or lower the treble or
bass levels; or adjust the balance
or
M between the left and the right
speaker
Press to see the status of the
LOUDNESS
loudness adjustment function
– LOUDNESS ON or LOUDNESS OFF.
Press LOUDNESS again to change the
setting
Press to accept all sound levels –
OK
SOUND OK? appears on the display
then
Press to store all sound levels
OK
If you have not stored your sound
adjustments...
Press to reset the sound levels to
RESET
their previously stored settings
N I C E T O K N O W

Adjusting sound

You can adjust the sound to suit your
personal taste and you can store the
adjustment as a permanent setting if
you like.
All you have to do is press the relevant
buttons on the panel and use the
M
buttons to adjust the sound.
The treble and bass levels can be raised
or lowered as you like and you can
alter the balance, that is, the distribu-
tion of sound emerging from the
loudspeakers to suit your listening
position.
The BeoSound 9000 also features a
loudness function which you can cut in
or out as you like, please refer to the
following page for further information
about loudness.
You can press RESET any time to reset
the sound levels to their original
settings.
However, if you want to turn your
adjustment into a permanent setting
of the BeoSound 9000, just press OK,
and the display reads SOUND OK?. Then
press OK one last time to store your
new sound setting.
Press to raise or lower the
volume
or
Press volume up and down at the
L
or
same time to mute speakers,
and
press again to activate speakers
Press to display A.SETUP* to adjust
LIST
sound
then
GO
then
Press to reveal BASS, TREBLE or
LIST
LOUDNSS
then
Press to adjust the treble or bass
levels or set loudness to on or off
or
Press to display S.STORE to store
LIST
your adjustments
then
GO
Press to reveal SPEAKER and
LIST
adjust balance
then
t t Press to adjust the balance
or
between the left and the right
s s speaker
To store your balance adjustment...
Press LIST repeatedly to display A.SETUP*,
then press GO, now press LIST to display
S.STORE and press GO to store your
adjustment.
*Note: In order to display A.SETUP on
Beo4, you have to add this function to the
Beo4 list of functions, please refer to the
Beo4 User's guide and the chapter
Customizing your Beo4 for further
instruction.
BEO4