Connecting Wirelesshd Devices (Eh-Tw6100W Only); Removing The Interface Cover; Connecting An Hdmi Cable Clamp - Epson EH-TW6100W User Manual

Preparing

Connecting WirelessHD devices (EH-TW6100W only)

The projector receives transmissions from the WirelessHD Transmitter, and projects the images.
Change the projected image by pressing the
control panel.
c
•
When receiving WirelessHD images, make sure WirelessHD is set to On.
WirelessHD p.71
•
You can change which device is displayed by selecting a device from Device Connections in HDMI
Link. HDMI Link-Device Connections
s

Removing the Interface Cover

The interface cover is attached to the connector section on the rear of EH-TW6100W. Remove this cover when
using a cable to connect a device.
There are gaps at the bottom of the interface cover that allows you to pull the cover forward and lift it from
the grooves at the top.
c
•
When reattaching, first insert the protruding sections into the grooves at the top.
•
Make sure you store the interface cover safely, as you need this when transporting the projector.

Connecting an HDMI Cable Clamp

If the HDMI cable is thick and hangs down, make sure you secure it to the cable holder with an HDMI clamp
so that the cable's weight does not disconnect it from the port.
button on the remote control or the
p.60
20
p.49
s
button on the
Settings -
s