Indicator Status During Normal Operation - Epson EH-TW6100W User Manual

Troubleshooting
Indicators
Lamp Error
Lamp Failure
(red)
High Temp Error
(Overheating)
(red)

Indicator status during normal operation

Indicators
Standby condition
(blue)
Warm-up in progress
(blue)
Cool-down in pro-
gress
(blue)
Status
There is a problem with the lamp, or it failed to turn on.
•
Disconnect the power cable, and then check if the lamp is
cracked. s
If it is not cracked, reinstall the lamp and turn on the power.
If reinstalling the lamp does not fix the problem, or if the lamp is
cracked, remove the power plug from the electrical outlet, and
contact your local dealer or the nearest Epson repair center.
Epson Projector Contact List
s
•
If the air filter is clogged, clean it. s
•
When using at an altitude of 1500 m or more, set High Altitude
Mode to On. s Extended - Operation - High Altitude
Mode
The internal temperature is too high.
•
The lamp turns off automatically and projection stops. Wait for
about five minutes. When the fan has stopped, disconnect the
power cable.
•
If the projector is installed next to a wall, make sure there is at
least 20 cm between the wall and the projector's exhaust vent.
•
If the air filter is clogged, clean it. s
•
If turning the power back on does not clear the problem, stop
using the projector and remove the power plug from the elec-
trical outlet. Contact your local dealer or the nearest Epson repair
center. s
Status
When you press the
button on the control panel, projection starts after a short
wait.
Warm-up time is about 30 seconds.
The power-off operation is disabled while the projector is warm-
ing-up.
All operations are disabled while the projector is cooling-down.
The projector enters standby condition when cool-down is com-
plete. If for any reason the power cable is disconnected during
cool-down, wait until the lamp has cooled down sufficiently
(about 10 minutes), reconnect the power cable, and then press
the
control panel.
78
Remedy
p.92
p.73
Epson Projector Contact List
Remedy
button on the remote control, or the
button on the remote control, or the
p.88
p.88
: Lit : Flashing : Off
button on the