BLADEZ VeloPro HW3017B Owner's Manual page 15

Getting familiar with the control panel
XLG EXERCISE COMPUTER-
SPECIFICATIONS :
TIME..................................................................00:00-99:59 MIN:SEC
SPEED....................................................... .....0.0- 999.9KM/H or ML/H
DISTANCE................................................................0 - 999.9 KM or ML
CALORIES......................................................... ...........0- 999.9KCAL
KEY FUNCTIONS:
MODE: To select a desired function. Hold the key for 4 seconds to have all function values
reset to zero (0) - total reset
SET: To input the target value.
RESET: To let the value reset.
KM/ML SWITCH ：Switch the unit to KM or ML
Follow the steps below to change measurement unit to English or metric
1) Remove batteries then set the switch to
2) Install batteries
OPERATION PROCEDURES:
AUTO ON/OFF
To conserve power, the monitor will automatically shut off if there is no speed signal sensed
or no key pressed in 4 minutes. The monitor will be auto-powered when the exercise begins
or at any key press
<1>TIME Displays work out time lapse while exercising.
Displays the current speed.
<2>SPEED
<3>DISTANCE Accumulates the distance while exercising.
<4>CALORIES Displays calories consumed while exercising.
Scans through each function between: TIME-
<5>SCAN
SPEED-CALORIES-DISTANCE.
BATTERY If there is an improper display on the monitor, Please
replace or change for new batteries. This monitor uses
two "AA" batteries. Always replace both batteries at the
same time.
Operation of the Monitor
ON(
13
2007 K/M
.
) for Mile or OFF( ) for KM