EAJ34001
Rear wheel installation
When installing the rear wheel, reverse the re-
moval procedure. Pay attention to the follow-
ing points:
1. Adjust the drive chain.
2. Make sure the following parts are proper-
ly torqued, and a new cotter pin is in-
stalled.
Tightening torque:
Axle nut:
105 Nm (10.5 m·kgf)
Tension bar bolt:
23 Nm (2.3 m·kgf)
EUU78000
WARNING
Always use a new cotter pin.
3. Adjust the rear brake. (See page 7-16)
EUU64500
WARNING
Check the operation of the brake light after
adjusting the rear brake.
7-37