Yamaha Virago XV250P Owner's Manual page 66

the swingarm and a match mark on each
chain adjuster. Use these marks to align
the rear wheel.
EUU33301
CAUTION:
Too little chain slack will overload the en-
gine and other vital parts. Keep the slack
within the specified limits.
5. After adjusting, be sure to tighten each
chain adjuster locknut and the axle nut.
Axle nut torque:
105 Nm (10.5 m·kgf)
6. Insert a new cotter pin into the axle nut
and bend the end of the cotter pin as
shown. If the notch in the axle nut and the
cotter pin hole do not match, tighten the
nut slightly to align them.
1. Cotter pin
EUU64700
WARNING
Always use a new cotter pin on the axle
nut.
7. Adjust the free play in the brake pedal.
EUU64500
WARNING
Check the operation of the brake light after
adjusting the rear brake.
7-24