Tools And Supplies Required; Torque Chart; Installation - Honda 08B08-MCH-100 Installation Instructions Manual

TOOLS AND SUPPLIES REQUIRED

Socket (8 mm)
Ratchet
Hex wrench (5 mm)
Phillips screwdriver
®
Cutting pliers
Isopropyl alcohol
Shop towel
Torque wrench

TORQUE CHART

Tighten all screws, bolts and nuts to their specified torques.
Refer to the Service Manual for the tightening torques of
removed parts.
Item
5 mm screw
6 mm SH flange bolt
6 mm socket bolt
2 of 10
N·m kgf·m Ibf·ft
4 0.4 2.9
9 0.9 6.5
10 1.0 7
08B08-MCH-1000-91

INSTALLATION

NOTE:
• Disconnect the negative cable from the battery before
installing this accessory.
• Trim the excess ends off the wire ties after attaching
them to the wire harnesses. Do not allow the cut part
of the wire tie to interfere with any harness or brake
hose.
• Be sure to observe all safety notes and precautions
described in the Service Manual while removing and
installing the fuel tank. Gasoline is extremely
flammable and is explosive under certain conditions.
Refuel in a well-ventilated area with the engine
stopped. Do not smoke or allow flames or sparks in
the area where gasoline is stored or where the fuel
tank is refueled.
1. Refer to the Service Manual to remove the parts.
BOLT
WASHER
FRONT TOP COVER
BOLT
LEFT SIDE
COVER
BOLT
LEFT CRANKCASE
REAR COVER
© 2006 American Honda Motor Co., Inc - All Rights Reserved.
NUT
WASHER
BOLT
SEAT
NUT
STAY
BOLT