Engine Oil Change - Honda EB10000 Owner's Manual

SERVICING YOUR GENERATOR

ENGINE OIL CHANGE

Drain the oil while the engine is warm to assure rapid and complete
draining.
1. Place a suitable container below the engine to catch the used oil.
2. Open the maintenance cover to access the oil filler cap.
3. Remove the oil filler cap, oil drain bolt and sealing washer, and drain
the oil into the container.
Improper disposal of engine oil can be harmful to the environment.
If you change your own oil, please dispose of the used oil properly.
Put it in a sealed container, and take it to a recycling center. Do not
discard it in a trash bin, dump it on the ground, or pour it down the
drain.
4. Install a new sealing washer and the oil drain bolt, and tighten the
bolt securely.
5. If it is difficult to fill the engine with oil, set the funnel contained in
the generator package to the oil filler port, and pour oil. Refill to the
upper limit mark on the dipstick with the recommended oil (see
page 45 ).
Maximum oil capacity:
Without oil filter replacement: approximately
With oil filter replacement: approximately
6. Tighten the oil filler cap securely. Close the maintenance cover.
Wash your hands with soap and water after handling used oil.
OIL FILLER CAP
44
FUNNEL
1.6 US qt (1.5 L)
1.8 US qt (1.7 L)
SEALING WASHER
OIL DRAIN BOLT