Appendix C: Setting Up Your Network Using Wps; Configuration Methods; Method One; Method Two - Zoom Wireless-N User Manual

Appendix C: Setting up Your Network
Using WPS
If all the wireless devices you plan to connect to your network support Wi-Fi Protected Setup
(WPS), you can use WPS to connect and secure your devices in one step. To use WPS follow the
instructions below.
Note: WPS configures one client device at a time. Please repeat the configuration method
for each client on your wireless network that supports WPS security.

Configuration Methods

WPS offers three configuration methods. Choose the method that is compatible with the
hardware and software options available on your "client device," which is the device you're
connecting wirelessly to the Wireless-N 4-port Router.

Method One

Use this method if your client device has a WPS button. This button can be either a physical
button on the unit or a software button in its application.
1
Press the WPS button on your Wireless-N 4-port Router and hold it in for three (3) seconds. The
Wireless light starts blinking rapidly. (Note: Wireless must be disabled for the WPS button to work. To
turn on wireless using the button on the Router, press the Wireless button on the Router and hold it for
5 seconds. Then press the same button which is also the WPS button as stated above.)
Important! The Registrar (the device configuring the WLAN) goes into the WPS mode and
the Enrollee (the device joining the WLAN) then looks for it. You should always start the
Registrar first. By default your Wireless-N 4-port Router is configured as a Registrar.
2
Click or press the WPS button on the client device.
Important! You must do this within two minutes after placing he Router into WPS
discovery mode.
3
Refer to your client device's documentation for further instructions, if necessary.

Method Two

Use this method if your client device already has a WPS PIN number. The client is the Enrollee.
1
If you haven't already done so, open a Web browser and type http://192.168.2.1 in the address bar.
a
When the Configuration Manager launches, log in as admin, then select Advanced
> Basic Settings > Wireless to open the Wireless Setup page.
b
Click the WPS Setup button to open the Wi-Fi Protected Setup page.
c
Select Enrollee PIN from the Setup option.
d
Enter the PIN number from your client device.
e
Click Trigger to start the connection process on the Router.
Important! You must do this within two minutes after placing the Router into WPS
discovery mode.
f
On the Wireless-N 4-port Router, when the program displays a message that the
process succeeded, click Save to save the configuration.